Back to Corby's Front Page   Corby is Access Control 
Sun Nov 3rd 2024    
 


Corby Tools
HR
    Bookmark Us
    Print this Page
    Register

Corby Pages
HR
    Contact Us
    Dealers
    Distributors
     Support
    Glossary
    Home
    Investor Corner
    Jobs
    Knowledge DB
    Linking to Corby
    Products
       Product List -htm
       Product List -pdf
       Product List -xls
       Product List -ods
    Purchasing Corby
    Software
    Terms of Service
    Training
     Track Package

Contact Info
 Corby Industries, Inc.
HR
 812 N Gilmore St
 Allentown, PA 18109
 United States of America
HR
 Phone
  (610) 433-1412
 Secure Fax
 (610) 435-1963
 more...

HR
Go get Firefox gif
Get Opera!
 
Valid XHTML!
Valid CSS!
 

6500 SA Series Keypad

The keypad will be a Corby 6500 Series or approved equal.

Architectural Specifications: The keypad will be a Corby 6500 Series or approved equal. Keypads will consist of a 12-button keypad and mounting plate. A removable and replaceable self-contained electronics module with a microprocessor will be attached to the rear of the keypad. Electronics module will contain four separate outputs which include a Form A/B main relay rated 5amp, Form C aux relay rated 1amp and two voltage switch outputs rated 50ma. Keypads will operate from 12 VDC or 24 VDC and consume 20ma. @ idle and 120ma. maximum. Connections will be made to wire "pigtails" of two removable pin type connectors.

Keypads will be programmable through the same 12 button keypad used to activate outputs. Keypads will accept 165 unique codes for operation of any or all of the outputs. Code and all programmable settings will be stored in non-volatile EEPROM memory and will not be lost when power is removed. Operating code length will be selectable from three to six digits. Keypads will return "on-line," in 60 seconds, if no data is entered while in program mode. Keypads will "timeout" when a partial code is entered and not completed within ten seconds. Keypads will be disabled for a user selectable time upon three consecutive invalid code entries.

Keypads will be available in a weatherproof version, with spring loaded cover to conceal the keypad, and without a cover. Keypads will be flush or surface mountable to a single gang electrical type box. Keypads will be 2.75" wide X 4.5" high X 1" deep. Weatherproof keypads without cover will be 3.23" wide X 5.0" high X 1" deep.